| Dispense Module (B-4905-H-QM) Installation |
Description |
Q'ty/Unit |
Description |
Q'ty/Unit |
Rewinder Ass'y |
1 |
Rewinder Guide Plate |
1 |
Rewind Full Sensor |
1 |
Screw (FL-4x6) |
4 |
Strip Sensor (Tr) |
1 |
Screw (SM-3x6B) |
1 |
Strip Sensor (LED) |
1 |
Screw (SM-4x6B) |
2 |
Rewind Paper Guide |
1 |
|
|
|
| 1. Remove the top cover and left side cover. |
2. Remove the operation panel.
(Fasten the rewind paper guide to the base with the two SM-4x8B screws.) |
 |
| 3. Pass the take-up harness of the rewinder ass'y and the longer harness of the
rewind full sensor through the hole of the main frame. Connect the take-up harness and
rewind full sensor harness to CN15 and CN5 on the CPU PC board respectively. Fix the
harness at two points with the clamps. |
| 4. Connect the connector of the rewind full sensor (LED) with the other harness
of the rewind ass'y. |
| 5. Align the notch of the take-up holder with the screw hole of the rewinder
ass'y and attach it to the printer with four FL-4 x6 screws. |
| 6. Attach the rewind full sensor (LED) to the base with SM-3 6B screw. |
| 7. Connect the shorter harness of the strip sensor (Tr.) with the trip sensor
harness (LED). |
| 8. Pass the other the strip sensor (Tr.) harness through the damp and connect to
CN5 on the CPU PC Board. |
| 9. Secure the strip sensors (Tr.) and (LED) with SM-4x6B screw. |
| 10. Fix the harness mentioned in Step 7 with the damp. Be sure to wire the
harness along with the main frame, base and right plate. |
 |
| 11. Reassemble the operation panel, top cover and left side cover in the reverse
order of removal. |
| 12. Set the DlP SW 1-5 to ON. |
 |
